Cone crusher or impact crusher are mainly the secondary crushers.It can break stone into suitable and required size with good cubic size.
Transformation of closed raw mill can still achieve a higher yield in the raw material into the mill when the water up to 3.5%, a 2.2 * 7m transformation of the cost of raw mill at the end of a few thousand dollars can, mill transformation time is generally not more than 24 hours, the same conditions, to step down production can be increased by about 20 to 80 percent.Second, the crushing jaw crusher modification technologies.
2-roller crusher is compression type crushersare is used for middle crushing and fine crushing of all kinds of ores and rocks.It is used for the crushing or medium-hard rock as well as for sticky and soft materials, lignite and mineral coal, clay, marl, limestone and similar raw materials as well as for overburden and ores.
Through the above table, we can find out which kind of rock level our material belongs to and then make a more accurate choice based on its performance and size so that it can give a better direction when choosing a right rock crusher.
The main structure of the pe series jaw crusher are composed of stander, eccentric shaft, belt pulley, flywheel, movable jaw plate, wrist plate ,adjustable gap screw, offsetting spring, fixed jaw plate.
Mark is a customer from tanzania.After clearly understanding mr.Marks requirements and on-site inspections, china hongxing manufacturer designed a special production line: the fixed jaw crusher is equipped as a coarse crushing machine and the impact rock crusher machine is the secondary crushing equipment.When the production program is completed, the quotation of the entire production line equipment will be sent to the customer in a short time.And our customer was very satisfied after seeing it.What are the advantages of the production program?.
Copyright© 2020 DRiveOn machinery.All rights reserved. Sitemap