Screening and grading: the crushed stone is evenly fed into the vu fm control screen through feeder.Grading the machine-made sand is to precisely control the graduation of machine-made sand.Then the unqualified materials would be sent back into the crushers to be crushed again and redundant stone powder would be collected by the dust separating and collecting system.
There are many methods for determining that the time has come to recondition your telsmith swing jaw assembly.It has brought you through the busy and slow times in your operating seasons, now its time to evaluate it for the 5 telltales of an impending pitman failure. confirming you have any 3 of these conditions usually gives you enough time to react and acquire necessary parts and start planning on repairs. use this information wisely as it can help you make informed decisions on your crusher and revenue streams.
All dmi vsi crushers come with tub & lid liners for wear protection heavy duty anvil ring differe.
Fixed jaw crusher: noise reduction noise is also a factor affecting energy conservation and environmental protection.According to the environmental protection survey report of 2015, noise not only threatens the living environment of human beings all the time but also harmsthe physical and mental health of human beings.Therefore, the radical treatment of noise is urgent to be solved.The emergence of noise cancellation circuitinstalled on the fixed jaw crusherimmediately attracts more attention from miners,because it not only fundamentally solves thenoise problem, but also improvesthe reliabilityonenergy conservation and environmental protection.the noise cancellation circuit is very flexible and it can be set on different parts of a jaw crusher according to the noise degree.
In addition to the maximum feed size, an important parameter of the crusher is the discharge gap.The discharge gap is not equal to the maximum discharge size.The maximum discharge size of the jaw crusher is usually 1.5-1.8 times of the discharge gap.Each crusher has a minimum discharge clearance.In order to ensure the stability of the crushing process, 1.5-2 times the minimum clearance is selected to complete the first stage of the fracture.
Raw ore material is commonly reduced in size using stone crusher such as cone crusher, jaw crusher, gyratory crusher, impact crusher.The crushed material can be scrubbed to break clays and agglomerated particles or rubbed to break down fragile gangue minerals for further removal by screening.Slimes may cause inefficiencies in the dms process through increased slurry viscosity, affecting the movement of fine particles.For materials that do not require scrubbing or other pretreatments, crushed product direct sent to the horizontal screen deck of the dms plant to remove the fine particles/slimes.
Copyright© 2020 DRiveOn machinery.All rights reserved. Sitemap